Before you start
- Use a Windows PC.
- Check your controller model before downloading.
- Close other controller software before installation.
Step 1: Download the correct Windows version
Go to the official Flydigi software page, then select the Flydigi Space Station version that matches your controller model. In this example, we are using Vader 5 Pro.
Step 2: Install Flydigi Space Station
Run the installer and allow any required Windows permissions during setup.
Step 3: Connect your controller
Open Flydigi Space Station, then connect your controller by USB cable or wireless dongle. For first-time setup, a wired or dongle connection is usually the most stable option.
Step 4: Confirm detection and update firmware if needed
When your controller appears in Flydigi Space Station, check for firmware updates and follow the on-screen instructions. Do not disconnect the controller during a firmware update.
Common issues
Controller not detected
Try another USB port or cable, connect directly to the PC instead of using a USB hub, then restart Flydigi Space Station.
Wrong app version installed
Check your controller model and make sure you installed the correct Flydigi Space version for that model.
Firmware update failed
Reconnect the controller, check your internet connection and try again using a direct USB connection.
What to prepare before contacting support
- Techyin order number, if available
- Controller model
- Serial number, if available
- Flydigi Space version
- Windows version
- A short photo or video showing the issue
