Flydigi Vader 4 Pro Calibration Guide

This guide explains how to perform a factory reset and manual calibration for the Flydigi Vader 4 Pro, including the gyroscope, sticks, and triggers.

Please follow the steps below if you are experiencing joystick, trigger, or motion control issues.

Before you start

Please make sure:

The controller is powered on.
The controller is connected and detected by your PC.
The controller has enough battery.
The triggers are set to Hall Effect mode before calibration, not micro-switch mode.

Factory reset

Turn the controller on, then press and hold the Select, Start, and Home buttons for about 5 seconds, until the RGB light strip blinks.

After the factory reset, reconnect the controller before starting calibration.

Manual calibration

Step 1: Enter calibration mode

Make sure the controller is connected and detected.

Press and hold Select, Start, and D-pad Up until the indicator light blinks red.

Step 2: Place the controller on a flat surface

Place the controller on a flat, stable surface for about 3 seconds.

Do not move the controller during this step, as this allows the gyroscope to calibrate correctly.

Step 3: Calibrate the sticks

Rotate each joystick fully 720 degrees.

Please rotate the sticks slowly and fully around the outer edge.

Step 4: Calibrate the triggers

Press both triggers at the same time.

Step 5: Exit calibration mode

Press and hold Select, Start, and D-pad Up again to exit calibration mode.

Test the controller again

After completing the factory reset and calibration, please test the controller again using a gamepad tester or the Flydigi Space Station software.

What to prepare before contacting support

If the issue continues after calibration, please contact Techyin Support with:

• Your order number
• The controller serial number
• A short video showing the issue

When recording the video, please make sure both the controller and the testing screen are visible at the same time while moving the joystick.